![]() ![]() You can verify this by pinging a well-known host:īecause of some reason, the network interface on my Raspberry was not being configured automatically. If the Ethernet cable is plugged in, and if you have a DHCP server active on your network, your Raspberry Pi’s network interface will automatically configure at boot up. Setting up networking on the Raspberry Pi ![]() Login with user name ‘root’ and password ‘root’.ĭetailed instructions for SD card setup are available on the following Raspberry Pi wiki page: You will be finally presented with a login prompt. You should see boot messages scrolling by on the screen (Fig. You can now connect the keyboard, mouse and monitor (and optionally the network cable) to the Raspberry Pi, insert the SD card into its slot and power on the board. I am assuming that your SD card is detected as a device ‘/dev/sdb’ on the GNU/Linux system you are using to write the image file. You will now see a directory called ‘archlinuxarm-13-06-2012.’ Change into this directory, verify the checksum of the file with ‘img’ extension resent in the directory and write it to your SD card using ‘dd’ command: So the name of the file that you have downloaded might be different from what you see above. The Arch Linux image files are continuously updated. ![]() I prefer Arch because of its simplicity and the ease with which you can keep packages updated.ĭownload the Arch Linux image and unzip it using the following command: The Raspberry Pi website (provides pre-built images for both Debian GNU/Linux and Arch Linux. The easiest way to get started with the Raspberry Pi is to use an SD card to store the file system image. Preparing the SD card using a GNU/Linux system An old TV set can also be used as a display by connecting it to the composite video output of the Raspberry Pi.Ī standard micro USB mobile charger (capable of handling at least 700 mA of current) can be used to supply power to the board. In case you have a monitor that accepts DVI inputs, you need an HDMI-to-DVI converter cable. Note that the device does not support VGA monitors-you have to use a monitor with DVI/HDMI inputs. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |